Acaution

; It is best to remove the top cover before you tilt back the printer as described in the steps below. Refer to Section 3.2.3.1 for instructions on removing the top cover.

; If you tilt back the printer with the top cover attached, be careful not to put too much weight on the top cover or any other printer components.

; Spread a thick, soft cloth under the printer before you follow the steps below.

; When you attach the bottom panel, make sure the parallel interface cable latch is not caught between the lower case and bottom panel.

Step 1: Remove the left and right side covers. (Refer to Section 3.2.3.2)

Step 2: On the right side of the printer mechanism, remove the CBS (O) screw securing the green and yellow earth cable and the earth plate together.

(Right side)

Figure 3-23. Connector and Earth Cable Removal (right side)

(Right side)

Figure 3-23. Connector and Earth Cable Removal (right side)

Step 3: From the left side, remove the two CPB(O)(M4X8) screws securing the green and yellow earth cables between the bottom plate of the printer mechanism and the earth on the bottom panel assembly.

Step 4: Disconnect the 6 connectors, (1) through (6) as shown in Figure 3-24.

Earth Cable

Q Flat Cable Connector (50-pin): @ CN4 (4-pin): © CN9 (7-pin):

Q Flat Cable Connector (50-pin): @ CN3 (2-pin): © CN5 (14-pin):

Earth Cable Mechanism CR Connector Option Cutter Printhead

Cover Open Sensor Panel Unit

Earth Cable

Q Flat Cable Connector (50-pin): @ CN4 (4-pin): © CN9 (7-pin):

Q Flat Cable Connector (50-pin): @ CN3 (2-pin): © CN5 (14-pin):

Earth Cable Mechanism CR Connector Option Cutter Printhead

Cover Open Sensor Panel Unit

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment