Figure Connector and Earth Cable Removal left side

Step 5: Open the rear cover. Remove the four CBB (M3x12) screws and two CB(M3x12) screws securing the interface cover and remove the cover. Step 6: Remove the 2 CB(M3x12) screws securing the optional interface cover and remove the cover.

CB(M3X12)

Optional Interface Cover.

Interface Cover,

CB(M3X12)

Interface Cover,

CBB(M3X12)

Rear Cover

Figure 3-25. Interface Cover Removal

CBB(M3X12)

Rear Cover

Figure 3-25. Interface Cover Removal

Step 7: While supporting the top cover to protect it from scratches, tilt back the printer and lay it on its back. Step 8: Remove the eight CBB (M4x16) screws securing the bottom panel assembly, and slowly remove the bottom panel unit assembly.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment