Paper Guide Assembly

Top Cover

Knob

Front Cover

Figure 4-4. Pre-Desassembly

Front Cover

Figure 4-4. Pre-Desassembly

¿^CAUTION

Remove the paper eject cover and the tractor unit by pushing and releasing the hooks at the both sides. When remounting them, be sure to snap these hooks on the projecting parts.

4.2.4 Upper Housing Removal

1. Remove the PAPER GUIDE ASSEMBLY, top cover, front cover, paper eject cover, knob and tractor unit. (See Section 4.2.3.)

2. Remove 2 CBS (M3 x 6) screws and a CBB (4 x 12) screw securing the upper housing to the lower case.

3. Set the release lever to the friction feed side.

4. Opening the front side of the upper housing a little, disconnect the Panel FFC from the connector in the panel assembly.

5. Opening the front side of the upper housing a little, release 2 hooks securing the panel assembly to the upper housing at the front bottom side of the upper housing. Then remove the panel.

6. Open the upper housing from the front side, and remove it .

Was this article helpful?

0 0

Post a comment