Hopper Retard Roller Unit Caution

Retard Roller

2 Lift up the Hopper toward the direction of the arrow, release the two tabs, and remove the spring and the hopper from the ASF Frame. 3 Remove Extension Spring 0.585 from both the ASF Frame and the Paper back Lever. 4 Remove the Paper Back Lever from the bearing of the ASF frame. 5 Remove Compression Spring 1.88 from the ASF Frame, and remove the Retard Roller Unit. Figure 4-8. Removing Retard Roller Unit Figure 4-8. Removing Retard Roller Unit When installing the Retard Roller or the Paper...

When removing the Waste Ink Tube from the Waste Ink Pad pay attention not to spill the ink

C67 Waste Ink Pad

6 Remove the Waste Ink Tube from the Waste Ink Pad. 6 Remove the Waste Ink Tube from the Waste Ink Pad. Figure 4-12. Removing Waste Ink Tube 7 Remove the Cap Unit from the two guide pins of the Housing, Lower Assy. Figure 4-12. Removing Waste Ink Tube 7 Remove the Cap Unit from the two guide pins of the Housing, Lower Assy. 8 Remove the four screws that secure the Housing, Lower Assy to the main unit.

CR Encoder Sensor Board

Sensor Epson R270

2 Remove the two screws that secure the CR Encoder Sensor Board to the IC Holder, and remove the CR Encoder Sensor Board. Figure 4-63. Removing CR Encoder Sensor Board Figure 4-63. Removing CR Encoder Sensor Board 2 Remove the two screws that secure the IC Holder Cover to the IC Holder, release the tab, and remove the IC Holder Cover. Figure 4-64. Removing IC Holder Cover Figure 4-64. Removing IC Holder Cover 3 Insert a flathead screwdriver or a similar tool into the six A sections located on...