PE Sensor BoardPE Detection Lever Idle Roller

1) Remove the Spool Gear 36.8/Extension Spring 0.143/Clutch. (p58)

2) Release the tab that secures the PE Sensor Board to the Holder Shaft Frame.

3) Release the cable from the Holder Shaft Frame, and remove the PE Sensor Board.

4) Release the shaft of the PE Detection Lever from the bearings of the Holder Shaft Frame, and remove Torsion Spring 0.22 from the PE Detection Lever.

5) Release the Idle Roller from the bearings of the Holder Shaft Frame.

Figure 4-39. Removing PE Sensor Board/PE Detection Lever/Idle Roller

Was this article helpful?

+1 0

Post a comment