EJ Frame AssyEJ Roller

□ Part/Unit that should be removed before removing EJ Frame Assy/EJ Roller

Document Cover / ASF Cover / Support Arm / Scanner Unit / Middle Case / Panel Unit / Printer Mechanism

When installing Spur Gear, 59. 6 and the EJ Roller, be sure to install new ones. These parts cannot be reused.

□ Removal procedure

■ EJ Frame Assy removal

1. Remove the Grounding Spring from the EJ Frame Assy.

2. Remove the screws (x2) and remove the EJ Frame Assy.

Figure 4-63. Removing EJ Frame Assy.

Figure 4-63. Removing EJ Frame Assy.

■ EJ Roller Removal

3. Insert a flathead screwdriver between the rib and the Spur Gear, 59.6 and push the gear in the direction of the arrow, and remove the Spur Gear, 59.6.

Figure 4-64. Removing EJ Roller (1) 4. Pull the bearing slightly (Arrow Q)), and remove the EJ Roller (Arrow (2)).

Figure 4-64. Removing EJ Roller (1) 4. Pull the bearing slightly (Arrow Q)), and remove the EJ Roller (Arrow (2)).

Figure 4-65. Removing EJ Roller (2)

■ After replacing the EJ Roller, perform the following adjustment (T.B.D.).

(Refer to Chapter 5 " ADJUSTMENT (p100)")

1. "Head Angular Adjustment"

2. "Bi-D Adjustment"

3. "PF Band Adjustment" (only after removal)

■ When the EJ Frame Assy or EJ Roller is reassembled, perform the required lubrication.

(Refer to Chapter 6 " MAINTENANCE (p108)")

Was this article helpful?

0 0

Post a comment