Power Supply Board

□ Part/Unit that should be removed before removing LD Roller/ASF Unit

Document Cover / ASF Cover / Support Arm / Scanner Unit / Middle Case / Panel Unit / Printer Mechanism

□ Removal procedure

1. Disconnect the connector cable from the connector (J1) of the Main Board.

CAUTION

Roller Epson
Figure 4-59. Removing Power Supply Board (1)

2. Remove the screw (x1), and remove the Power Supply Board in the direction of the arrow.

Figure 4-60. Removing Power Supply Board (2)

Power Supply Board

Figure 4-60. Removing Power Supply Board (2)

Do not turn the Power Supply Board upside down as shown in the figure below. This figure is only used to show the location of the parts and the harness arrangement.

3. Pull out the connector cable through the hole of the Frame Base.

3. Pull out the connector cable through the hole of the Frame Base.

Disassembly Epson Power Supply
Figure 4-61. Removing Power Supply Board (3)
Dx4450 Repair

Was this article helpful?

0 -2

Responses

  • filmon
    How to repair epson cx4300?
    9 years ago
  • alexander
    How to get to the power supply on a epson CX4400?
    9 years ago
  • EDILIO COCCI
    How to remove printhead from dx4450?
    9 years ago
  • RALPH
    How to remove the power supply of epson cx5500?
    8 years ago

Post a comment