Waste Ink Pads

□ Parts/Components need to be removed in advance

Document Cover/ASF Cover/Scanner Unit/Panel Unit/Upper Housing/Card Slot Cover/Lower Housing/Main Board Unit/Left Frame/Front Frame/Right Frame/CR Motor/CR Scale/Hopper/Main Frame Assy/ASF Unit/Ink System Unit/Star Wheel Holder Assy/EJ Roller/Front Paper Guide/PF Encoder Sensor/PF Scale/PF Roller

□ Removal procedure

1. Remove the Waste Ink Pads (x5) from the sections indicated with A to C of the Base Frame.

Waste Ink Pad R230 Replace
Figure 4-101. Removing the Waste Ink Pads

2. Remove the Waste Ink Cover and the Diffusion Sheet.

Figure 4-102. Removing the Waste Ink Cover and Diffusion Sheet

When installing the Diffusion Sheet, Waste Ink Cover, and the Waste Ink Pads (x2) on section B, attach them in the order given in the figure below.

Figure 4-103. Installing the Waste Ink Pads When installing the Waste Ink Cover, be sure to align the guide pin (x1) of the Base Frame with the positioning hole (x1) of the Waste Ink Cover as shown in Figure 4-102. Make sure to confirm the cover is properly secured on the Diffusion Sheet without any gap.

Figure 4-103. Installing the Waste Ink Pads When installing the Waste Ink Cover, be sure to align the guide pin (x1) of the Base Frame with the positioning hole (x1) of the Waste Ink Cover as shown in Figure 4-102. Make sure to confirm the cover is properly secured on the Diffusion Sheet without any gap.

Whenever the Waste Ink Pads is removed/replaced, the required adjustments must be carried out.

Figure 4-102. Removing the Waste Ink Cover and Diffusion Sheet

Was this article helpful?

0 0

Responses

  • phoebe
    How to remove printhead epson cx 8300?
    8 years ago
  • Rita Sebhat
    Where is the waste ink pad on epson sx200?
    8 years ago
  • barbara
    How to dismantle waste ink pad for stylus tx200?
    6 years ago

Post a comment