How Do You Remove The Top Cover Of An Epson Stylus Photo Rx430

Combination Gear 22.8, 7.762

Driven Holder

Scanner Timing Belt

Driven Holder

Scanner Timing Belt

Hinge L

Scanner HP Sensor Connector Cable

Scanner HP Sensor

Scanner HP Sensor Connector Cable

Scanner HP Sensor

Hinge L

| Driven Holder Spring

Scanner Motor Unit

Figure 4-12. Scanner Motor Unit/Scanner HP Sensor/Driven Holder Spring

Removal

Move Scanner Carriage Unit to the center.

Release Scanner Timing Belt from Combination Gear 22.8, 7.762 and Driven Holder.

Release the shaft of Hinge L from the socket of Scanner Housing Lower.

Release Scanner Motor Connector Cable and Scanner HP Sensor Connector Cable from the hook of Hinge L, and then pull from the notch of Scanner Housing Lower.

Place Scanner Motor Connector Cable and Scanner HP Sensor Connector Cable as shown in the figure.

Remove the screw (xl, O) for securing Scanner HP Sensor, and then remove Scanner HP Sensor.

Align the positioning hole (xl, □) of Scanner HP Sensor with the dowel (xl) of Scanner Housing Lower.

Release Scanner Motor Connector Cable and Scanner HP Sensor Connector Cable from the hook of Scanner Housing Lower while holding Scanner Carriage Shaft.

Remove the screws (x2, ) for securing Scanner Motor Unit, and then remove Scanner Motor Unit.

Align the positioning holes (x2) of Scanner Motor Unit with the dowels (x2, □) of Scanner Housing Lower.

Remove Driven Holder Spring from Scanner Housing Lower by using tweezers.

Insert Driven Holder Spring into the rib of Driven Holder.

4.3.5 Panel Unit

□ External View

Figure 4-13. Panel Unit Removal

□ Part/Unit that should be removed before removing Panel Unit.

Document Cover / Scanner Unit

□ Removal procedure

1. Peel off Panel Sheet from Panel Unit by using a precision screwdriver (-). CAUTION

Was this article helpful?

0 0

Responses

  • CIRO
    HOw to remove top cover epson cx4200?
    8 years ago
  • elisa
    How to remove the scanner lid from rx420?
    6 years ago

Post a comment